0.4-5x550 mm Zımpara ve fırçalama hattı( Bobinden bobine)

Line Type: 3 Heads Grinding line (Coil to Coil)                      

General descriptions

Min /Max Thickness:0.4-5 mm Manufacturer Year:2015

Max Width :1000 mm

Material: Stainless steel

Brand: COSTA

Origin: USA

Costa Granding descriptions

Equipment with the following working units: C25 + C25 + C25

-General technical data:

-Useful working width : 550 mm

-Longitudinal sanding belt length : 5250 mm

-Width of longitudinal sanding belts to obtain maxirnum working width :W. Width + 30 mm

-Sanding belt introduction side (standard) :Left hand

-Sanding belt oscillation system with electronic photocell - complete with safely micro-switches to -stop the machine in case of abrasive belt breakage/mistracking, and a timed activated air jet blower for photocell automatic cleaning.

-Standard working thickness :0,4-5.0 mm

-Constant pass-line height of feed table from floor :1000 mm

-Lifting/lowering of the head with the working units with motorvariator

-Rubber-covered roller, positioned in front of machine; it's connected to emergency switches; activated it causes the stop in emergency and the thickness opening to prevent damages.

1nd & 2nd & 3nd Top Working unit:

C25-Working unit with cylinder ø mm 250. Complete with: sanding bell tensioning unit; electronic oscillation; dust hoods; safety systems.

It includes an eccentric an eccentric mechanism for compensating the variation of thickness of the abrasive belt.

-Contact cylinder covered with special rubber oil and heat resistant

-Grit-Set with electronic control of the position of cylinder. Centesimal digital read-out with setting of cylinder from control panel. Position Stand-By with pneumatic exclusion of cylinder in case of stop in emergency.

-Oversized excursion of the cylinder unit, to allow the utilization of the Scotch-Brite belt

-Motor controlled by inverter, for step less cutting speed variation, power :22 kW

-Cutting speed of sanding belt :3-25 m/s

-Inversion of sanding belt rotation, with automatic resetting of sanding bell oscillation.

-IE2-02 - Motor with efficiency IE2 (ex efficiency 1)

-B1 - Oscillating air jet blowers for sanding belt cleaning, with auxiliary dust hood

EQUIPMENT LIST

-Entry Coil Car-L Type

-Uncoiler & Upper press roll

-Peeler table

-Staightener

-Costa granding (3 head-1 unit)

-Tension bradle roll

-Peeler Table -Recoiler -Exit Coil Car-L type